Makita XBU02PT XBU02 Instruction Manual - Page 6

For continuous operation, pull the switch trigger, push in the lock button and then release the switch trigger. To stop the tool from the locked position, pull the switch trigger fully, then release it. Speed change 1 1. Adjusting dial To install the long nozzle: 1. Align the small projection of the housing with the groove of the long nozzle. 2. Slide in the long nozzle, and turn it clockwise until the triangle markings on the long nozzle and the housing meet each other. 015477 The maximum air volume can be adjusted just by turning the adjusting dial. This can be done even while the tool is running. The dial is marked 1 (lowest) to 6 (highest). NOTICE: The speed adjusting dial can be turned only as far as 6 and back to 1. Do not force it past 6 or 1, or the speed adjusting function may no longer work. When working in a high temperature circumstance, the tool may be stopped because of the overheat protection system. In that case let the tool cool down. Avoid setting to speed 6 (highest) in high temperature circumstances. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing the long nozzle 015481 The length of the nozzle can be adjusted by changing the locking position. Installing the shoulder strap (optional accessory) 015482 Hook the shoulder strap onto the hanger of the tool. Before use, adjust the length of strap so that it is easy to work with it. OPERATION Blowing 1. Long nozzle 2 2 2. Triangle marking 015484 1 015480 6