Makita XDT01 Instruction Manual - Page 5
Functional Description
View all Makita XDT01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 1. Red indicator 1 2. Button 3. Battery 2 cartridge 3 014065 CAUTION: • Always switch off the tool before installing or removing of the battery cartridge. • Hold the tool and the battery cartridge firmly when installing or removing battery cartridge. Failure to hold the tool and the battery cartridge firmly may cause them to slip off your hands and result in damage to the tool and battery cartridge and a personal injury. To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge. To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Insert it all the way until it locks in place with a little click. If you can see the red indicator on the upper side of the button, it is not locked completely. CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. NOTE: • Continuing to pull the trigger switch for more than 130 seconds will stop the tool. Electric brake This tool is equipped with an electric brake. If the tool consistently fails to quickly stop after switch trigger release, have tool serviced at a Makita service center. Lighting up the front lamp CAUTION: • Do not look in the light or see the source of light directly. 1. Lamp 1 009209 1. Light button SH CAUTION: • Always install the battery cartridge fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. • Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not being inserted correctly. Switch action 1. Switch trigger 1 014070 Every time the light button on the switch panel is pressed, the light status is alternatively changed from the ON to the OFF and from the OFF to the ON. With the light button in the ON status, pull the switch trigger to turn on the light. To turn off, release it and the light goes out approximately 10 seconds after releasing. With the light button in the OFF status, even if the trigger is pulled, the lamp will not light on. 1 009208 NOTE: • To make sure the status of light, pull the trigger. When the lamp lights up by pulling the switch trigger, the light switch is in the ON status. When the lamp does not come on, the light switch is in the OFF status. 5