Makita XDT01 Instruction Manual - Page 6
Changing the hammering force
View all Makita XDT01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
• During the operation of switch trigger, the light status cannot be changed. • For approximately 10 seconds after releasing the switch trigger, the light status can be switched. Reversing switch action 1. Reversing switch lever A B 1 009211 This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. • Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. • When not operating the tool, always set the reversing switch lever to the neutral position. Changing the hammering force 1 SH 2 3 SH SH 4 011217 1. Changed in three steps 2. Hard SH 3. Medium 4. Soft 5. Hammering 5 force button Hammering force grade Maximum displayed on panel blows Application Hard SH 3,400 /min Tightening when force and speed are desired. Work Tightening in underwork material/ Tightening long screws/ Tightening bolts. Medium SH Tightening when a good 2,800 /min finishing is needed. Tightening in the finishing board, plaster board. Soft SH 1,300 /min Tightening when excessive tightening need to be avoided because of potentially clogged female screw and broken or damaged screw head. Tightening sash screw/ Tightening small screws such as M6. 014072 The hammering force can be changed in three steps: hard, medium and soft. This allows a tightening suitable to the work. Every time the hammering force button is pressed, the number of blows changes in three steps. For approximately one minute after releasing the switch trigger, the hammering force can be changed. NOTE: • When all lamps on the switch panel go out, the tool is turned off to save the battery power. The hammer force grade can be checked by pulling the switch trigger to the extent that the tool does not operate. • During the operation of switch trigger, the hammer force grade cannot be changed. 6