Makita XHU04Z XHU04Z Instruction Manual - Page 10
CAUTION, Installing the shear blades
View all Makita XHU04Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
1 2 1. Screws 2. Shear blade 011257 CAUTION: • Return the gear to the original position in such a manner as it was installed if it should be taken away by mistake. Installing the shear blades Prepare 4 removed screws (For under cover), 2 screws (For shear blade), plate, under cover, and new shear blades. Adjust the crank position as shown in the figure. At this time, apply some grease provided with new shear blades to the periphery of the crank. 1. Crank 1 009302 Place the new shear blades on the tool so that the oval holes in the shear blades fit onto the crank. Overlap the holes in the shear blades with the screw holes in the tool and then secure them with two screws. 1 1. Oval hole of shear blade 2. Crank 3. Screws 3 2 014773 Check the crank for smooth turn with a slotted screwdriver. 1. Crank 011258 Overlap the oval hole in the upper blade with that in the lower one. 1. Oval hole of 1 shear blade 011259 Take out the blade cover from the old shear blades and fit it onto the new ones for easy handling during the replacement of blades. 1 011261 Install the plate, under cover on the tool. Tighten the screw firmly. NOTE: • There is no distinction between the top and bottom of the plate. Remove the blade cover and then turn on the tool to check it for proper movement. NOTE: • When the shear blades does not operate properly, there is a poor fit between the blades and crank. Redo from the beginning. 10