Makita XHU07Z XHU07 XHU08 Instruction Manual - Page 11

NOTICE: Be sure to attach 2 long screws to the center holes. NOTICE: If the shear blades do not move smoothly, the shear blades are not engaged with the rods properly. Install the shear blades again. NOTICE: If the parts other than the shear blades such as the rods are worn out, ask Makita Authorized Service Centers for parts replacement or repairs. Installing or removing the chip receiver Optional accessory CAUTION: When installing or removing the chip receiver, always wear gloves so that your hands do not directly contact the shear blades. NOTICE: The blade cover cannot be installed if the chip receiver is installed on the tool. Before carrying or storing the tool, uninstall the chip receiver, and then install the blade cover to avoid blade exposure. NOTICE: Be sure to remove the blade cover before installing the chip receiver. The chip receiver gathers discarded leaves and makes clean-up afterward much easier. It can be installed on either side of the tool. To install the chip receiver, align the tip of the shear blades with the tip of the chip receiver, and then press the chip receiver against the shear blades so that the hooks fit into the grooves on the shear blades. 1 1 NOTICE: Make sure that the chip receiver does not overlap the branch catcher. 1 ► 1 . Branch catcher To remove the chip receiver, press the levers on both sides to release the hooks. 1 ► 1 . Lever NOTICE: Never try to remove the chip receiver by an excessive force with its hooks locked in the grooves of the shear blades. ► 1 . Hook OPERATION WARNING: Keep hands away from shear blades. ► 1 . Hook 1 11 ENGLISH