Makita XMT03Z Instruction Manual - Page 4
Save These Instructions., Symbols, Important Safety, Instructions, For Battery Cartridge - manual
View all Makita XMT03Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
9. Do not leave the tool running. Operate the tool only when hand-held. 10. Always switch off and wait for the blade to come to a complete stop before removing the blade from the workpiece. 11. Do not touch the application tool or the workpiece immediately after operation; they may be extremely hot and could burn your skin. 12. Do not operate the tool at no-load unnecessarily. 13. Always use the correct dust mask/respirator for the material and application you are working with. 14. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Follow material supplier safety data. 15. This tool has not been waterproofed, so do not use water on the workpiece surface. 16. Ventilate your work area adequately when you perform sanding operations. 17. Use of this tool to sand some products, paints and wood could expose user to dust containing hazardous substances. Use appropriate respiratory protection. 18. Be sure that there are no cracks or breakage on the pad before use. Cracks or breakage may cause a personal injury. 19. Do not use accessories which are not specifically designed and recommended by the tool manufacturer. Just because the accessory can be attached to your power tool, it does not assure safe operation. 20. Wear personal protective equipment. Depending on application, use face shield, safety goggles or safety glasses. As appropriate, wear hearing protectors, gloves and workshop apron capable of stopping small abrasive or workpiece fragments. The eye protection must be capable of stopping flying debris generated by various operations . The dust mask or respirator must be capable of filtrating particles generated by your operation. Prolonged exposure to high intensity noise may cause hearing loss. 21. Keep bystanders a safe distance away from work area. Anyone entering the work area must wear personal protective equipment. Fragments of workpiece or of a broken accessory may fly away and cause injury beyond immediate area of operation. 22. Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the power tool out of your control. 23. Do not run the power tool while carrying it at your side. Accidental contact with the accessory could snag your clothing, pulling the accessory into your body. 24. Do not operate the power tool near flammable materials. Sparks could ignite these materials. 25. Do not use accessories that require liquid coolants. Using water or other liquid coolants may result in electrocution or shock. 26. Always be sure that the tool is switched off and unplugged or that the battery cartridge is removed before carrying out any work on the tool. 27. Always be sure you have a firm footing. Be sure no one is below when using the tool in high locations. SAVE THESE INSTRUCTIONS. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. USD301-4 Symbols The followings show the symbols used for tool. ・ volts ・ direct current ・ rated speed ・ no load speed ・ revolutions or reciprocation per minute IMPORTANT SAFETY INSTRUCTIONS ENC007-8 FOR BATTERY CARTRIDGE 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. 2. Do not disassemble battery cartridge. 3. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. 4