Makita XMT03Z Instruction Manual - Page 8
Sanding, Dust extraction attachment, optional accessory
View all Makita XMT03Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Dust extraction attachment (optional accessory) 1 014559 Put the application tool on the workpiece. And then move the tool forward so that the application tool movement does not slow down. NOTE: • Forcing or excessive pressure on the tool may reduce efficiency. • Before cutting operation, it is recommended to preset the orbital stroke rate 4 - 6. • Remove sawdust by drawing the tool adequately. It increases work efficiency. • The round saw is recommended for cutting long straight line. Sanding CAUTION: • Do not reuse a sanding paper used for sanding metal to sand wood. • Do not use a worn sanding paper or sanding paper without grit. 014560 Apply a sanding paper on the workpiece. NOTE: • Using a test material sample to try is recommendable to determine a correct orbital stroke rate suitable for your work. • Use a sanding paper with the same grit until sanding the whole workpiece is completed. Replacing a sanding paper with different grit sanding paper may not get a fine finish. 7 8 3 4 2 5 6 1. Nozzle band 2. Dust nozzle 3. Dust attachment 4. Felt ring 5. Pad 6. Holder bolt 7. Holes in the tool 8. Protrusions on the nozzle band 014561 • Install dust nozzles and dust attachment. • Install the nozzle band on the tool so that its protrusions fit in the holes in the tool to secure it. • Put the felt ring and the sanding pad on the dust attachment and then secure them with the application tool installation bolt. 014562 When you wish to perform cleaner operation, connect a vacuum cleaner to your tool. Connect a hose of vacuum cleaner to the dust extraction attachment (optional accessory). 8