Makita XOB01 XOB01 Instruction Manual - Page 5

Lithium-ion batteries with a star marking are equipped with a protection system. This system automatically cuts off power to the tool to extend battery life. The tool will automatically stop during operation if the tool and/or battery are placed under one of the following conditions: • Overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, stop the application that caused the tool to become overloaded. Then press the start/speed adjusting button again to restart. If the tool does not start, the battery is overheated. In this situation, let the battery cool before pressing the start/speed adjusting button. • Low battery voltage: The remaining battery capacity is too low and the tool will not operate. In this situation, remove and recharge the battery. Switch action and speed adjusting button 1. Stop button 1 2. Start/speed adjusting button ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing abrasive disc 1. Pad 2. Abrasive disc 1 2 012875 To install the abrasive disc, first remove all dirt or foreign matter from the pad. Then attach the abrasive disc to the pad. Be careful to align the holes in the abrasive disc with those in the pad. Installing dust bag (optional accessory) 1 1. Dust bag 2 012878 To start the tool, press the start/speed adjusting button. The tool starts with high speed mode. Each time you press the start/speed adjusting button, the speed mode changes in an order of hi speed, middle speed, and low speed. To stop the tool, press the stop button. Refer to the table for the relationship between the speed mode and the kind of work. 012876 Install the dust bag on the tool with its mouth directing downwards. Emptying dust bag 1. Dust nozzle Speed mode Number of rotations Usage High Middle 11,000 9,500 Regular sanding Finish sanding Low 7,000 Polishing 012897 NOTE: • The table shows standard applications. They may differ under certain conditions. 1 003323 When the dust bag is about half full, switch off the tool, and remove the dust bag from the tool. Then remove the dust nozzle from the dust bag after unlocking the dust nozzle by turning it slightly counterclockwise. Empty the dust bag by tapping it lightly. 5