Makita XPT02Z XPT02 Instruction Manual - Page 8
Changing the impact force impact, driver mode, Changing the torque setting, screwdriver mode
View all Makita XPT02Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Changing the impact force (impact driver mode) 1 2 5 3 4 ► 1 . Changed in three steps 2. Hard 3. Medium 4. Soft 5. Control button Impact force grade displayed on panel Maximum blows Application Hard 3,200 (/min) Tightening when force and speed are desired. Medium 2,400 (/min) Tightening when a good finishing is needed. Work Tightening in underwork material/ Tightening long screws/ Tightening bolts. Tightening in the finishing board, plaster board. Soft Tightening when excessive 1,200 (/min) tightening need to be avoided Tightening sash screw/ because of potentially clogged Tightening small screws female screw and broken or such as M6. damaged screw head. The impact force can be changed in three steps: hard, medium and soft. This allows a tightening suitable to the work. Every time the button is pressed, the impact force grade changes in three steps. For approximately one minute after releasing the switch trigger, the impact force can be changed. NOTE: During the operation of switch trigger, the impact force grade cannot be changed. 8 Changing the torque setting (screwdriver mode) The fastening torque can be adjusted by pressing the button in screwdriver mode. The numbers on the LED display shows torque setting. The fastening torque is minimum at the number 1 and maximum at the number 9. The indication "P" is a special mode for fastening self drilling screws. Every time the button is pressed, the torque setting changes from 1 to 9 and P, and then returns to 1. The torque setting changes fast by keeping pressing the button. P mode is suitable for fastening self drilling screws into steel plates in the following conditions. ENGLISH