Makita XRM02W Instruction Manual - Page 9

Recall stations from preset memories 1. Press the Power button to turn on the radio. 2. Select the required waveband. 3. Momentarily press the required Preset button, the preset number and station frequency will appear in the display. Setting the radio alarm When the radio alarm is selected, the radio will turn on and play the chosen radio station at the chosen alarm time. The radio alarm will continue for one hour unless turned off by pressing the Power button. Pressing the Power button whilst the alarm is activated will cancel the alarm for 24 hours. Note: When the radio is in low battery status, the radio alarm can't be activated. a. Setting radio alarm time: 1. The radio alarm can be set either when radio is on or off. 2. Press and release radio alarm button , the radio alarm symbol will flash. 3. During radio alarm symbol flashing, press button for more than 2 seconds followed by a beep. 4. Display Hour will flash, rotate Tuning/Volume control knob to select the hour then press button again to confirm hour setting. 5. Follow same procedures of setting hour to set required minute. Press button to complete alarm time setting. b. Setting radio alarmed station 1. During setting radio alarm time and radio alarm symbol is flashing, press Band button to activate the radio to select required wake-up band and station by manual tuning and recall the preset stations. Press button to complete radio alarm setting. Display will show . 2. When above radio alarm time and station are set, press and hold down radio alarm button for 2 seconds followed by a beep to switch alarm on or off. Display will show when radio alarm is set. Note: If new radio alarm station is not selected, it will select the last alarm station. Setting the HWS (Humane Wake System) buzzer alarm A beep tone will activate when selecting the HWS buzzer alarm. The alarm beep will become shorter every 15 seconds for one minute followed by one minute silence before repeating the cycle. The HWS alarm will sound for one hour until turning off by pressing the Power button. Press the Power button whilst the alarm is activated will cancel the alarm for 24 hours. 1. The HWS buzzer alarm can be set either radio is on or off. 2. Press and release the HWS buzzer alarm button , the symbol will flash. 3. During the symbol flashes, long pressing the button for more than 2 seconds followed by a beep and display Hour digit will flash. 4. Rotate Tuning/Volume control knob to select required alarm hour, then press time set button again. The minute digit will then flash. 5. Rotate Tuning/Volume control knob to select required alarm minute, the press time set button again to complete HWS buzzer alarm setting. 6. Press and hold down buzzer alarm button for more than 2 seconds followed by a beep to switch on or off the HWS buzzer alarm. Display will appear when buzzer alarm has been set. Snooze function 1. Whilst the alarm is activated, pressing any buttons except the Power button will activate the snooze function. The radio or HWS buzzer alarm will be silenced with interval of 5 minutes. 2. The display will flash both the snooze symbol and the alarm symbol. The snooze function can be repeatedly during one hour that the alarms are active. Sleep function The sleep timer will automatically switched off the radio after a preset time has elapsed. 1. Press and continue to hold down the Power button for more than 2 seconds, followed by a beep tone, the display will cycle through the available sleep times in the order 60-45-30-15-120-90-60. Release the Power button when the required sleep time appears in the display. The symbol will appear in the display and the radio will play the last station selected. 2. To cancel the sleep function, press the Power button. The Symbol will disappear and radio is off. Display illumination Press any buttons or rotate Tuning/Volume control knob will illuminate the LCD display for approx. 15 seconds. During scanning stations and alarm activated, will also automatically illuminate the display. Change Stereo to Mono When the stereo FM station reception is weak, you can improve it by pressing Mono button for 2 seconds. The sound is no longer in stereo and stereo indicator disappears. 9