Makita XRU15PT XRU15 Instruction Manual - Page 12

Installing the protector WARNING: Never use the tool without the guard illustrated in place. Failure to do so can cause serious personal injury. CAUTION: Take care not to injure yourself on the cutter for cutting the nylon cord. Attach the protector to the clamp using bolts. 1 2 3 ► 1 . Clamp 2. Protector 3. Cutter Installing the cutting tool CAUTION: Always use the supplied wrench(es) to remove or to install the cutting tool. CAUTION: Be sure to remove the hex wrench inserted into the tool head after installing the cutting tool. NOTE: The type of the cutting tool(s) supplied as the standard accessory varies depending on the countires. The cutting tool is not included in some specifications of the model. NOTE: Turn the tool upside down so that you can replace the cutting tool easily. NOTICE: Be sure to use genuine Makita nylon cutting head. 6 1 5 2 4 3 2. Place the nylon cutting head onto the spindle and tighten it securely by hand. 3. Remove the hex wrench from the tool head. To remove the nylon cutting head, follow the installation procedures in reverse. OPERATION Attaching the shoulder harness CAUTION: Always use the shoulder harness attached to the tool. Before operation, adjust the shoulder harness according to the user size to prevent fatigue. CAUTION: Before operation, make sure that the shoulder harness is properly attached to the hanger on the tool. 1. Wear the shoulder harness on your left shoulder. 2. Clasp the hook on the shoulder strap to tool's hanger. 2 1 ► 1 . Hook 2. Hanger ► 1 . Nylon cutting head 2. Receive washer 3. Spindle 4. Hex wrench 5. Tighten 6. Loosen 1. Insert the hex wrench through the hole in the tool head to lock the shaft. Rotate the shaft until the hex wrench is fully inserted. 12 ENGLISH