Makita XSJ01 Instruction Manual - Page 7
Operation, Maintenance
View all Makita XSJ01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Hex wrench storage 1. Hex wrench 1 009021 When not in use, store the hex wrench as shown in the figure to keep it from being lost. Carry hook The carry hook is convenient for temporarily hooking the tool. It can be installed on either side of the tool. When removing the carry hook, widen it by pressing its right ends ON BOTH SIDES in the directions of arrow (1) and raise it in the direction of the arrow (2). 1. Hook 1 2 1 1 009015 OPERATION 009020 1 2 1. Side blade 2. Side blade surface 3. Center blade 4. Workpiece CAUTION: • Edges and chips of the workpiece are sharp. Wear gloves. Otherwise it can cause injury. Secure the workpiece firmly. Move the tool forward keeping the side blades flush with the workpiece surface. Adjusting shear blade 1 2 3 4 5 1. Screws 2. Side blade L 3. Center blade 4. Side blade R 5. Sleeve 009019 Adjust the side blade L so that the curl of waste material does not contact the cutting head or the workpiece. Use the hex wrench to loosen the three screws which hold the cutting head. Move the side blade L back and forth to adjust it. Then tighten the three screws with the hex wrench. MAINTENANCE CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. • Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. Lubrication 1 2 3 4 5 1. Screws 2. Side blade L 3. Center blade 4. Side blade R 5. Lubricate 009022 Before operation, lubricate the contact point of the center blade and the side blades R/L. And, also lubricate the point of the center blade near the cutting head. To keep good cutting performance, use lubricant from time to time during operation. 3 4 009018 7