Makita XUX01Z XUX01 Instruction Manual - Page 8

Indicator Mode High Medium Electronic torque control function The tool electronically detects a sudden drop in the rotation speed which may cause a kickback. In this situation, the tool automatically stops to prevent further rotation of cutting tool. To restart the tool, release the switch trigger. Clear the cause of sudden drop in the rotation speed and then turn the tool on. NOTE: This function is not a preventive measure for kickbacks. Low ASSEMBLY Reverse button for debris removal WARNING: Switch off the tool and remove the battery cartridge before you remove entangled weeds or debris which the reverse rotation function can not remove. Failure to switch off and remove the battery cartridge may result in serious personal injury from accidental start-up. This tool has a reverse button to change the direction of rotation. It is only for removing weeds and debris entangled in the tool. To reverse the rotation, tap the reverse button and pull the trigger when the tool's head is stopped. The power lamp starts blinking, and the tool's head rotates in reverse direction when you pull the switch trigger. To return to regular rotation, release the trigger and wait until the tool's head stops. WARNING: Always be sure that the tool is switched off and battery cartridge is removed before carrying out any work on the tool. Failure to switch off and remove the battery cartridge may result in serious personal injury from accidental start-up. WARNING: Never start the tool unless it is completely assembled. Operation of the tool in a partially assembled state may result in serious personal injury from accidental start-up. Mounting the handle Attach the handle with supplied clamps and bolts. Make sure that the handle is located between the spacer and the arrow mark. Do not remove or shrink the spacer. 2 1 3 5 4 3 1 ► 1 . Reverse button NOTE: During the reverse rotation, the tool operates only for a short period of time and then automatically stops. NOTE: Once the tool is stopped, the rotation returns to regular direction when you start the tool again. NOTE: If you tap the reverse button while the tool's head is still rotating, the tool comes to stop and to be ready for reverse rotation. ► 1 . Handle 2. Hex socket bolt 3. Clamp 4. Spacer 5. Arrow mark Attach the barrier (country specific) to the handle using the screw on the barrier. Once assembled, do not remove the barrier. 1 2 ► 1 . Barrier 2. Screw 8 ENGLISH