Marantz AV8802A Owner s Manual in English - Page 28

Contents Connections Playback o Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7 Q8 Q9 . I NETWORK connector Used to connect to a LAN cable when connecting to a wired LAN network. (v p. 77) J USB port This is used to connect USB storages (such as USB memory devices) and the USB cable supplied with iPod. (v p. 72) K AC inlet (AC IN) Used to connect the power cord. (v p. 82) L FM/AM antenna terminals (ANTENNA) Used to connect FM antennas and AM loop antennas. (v p. 75) M BALANCED XLR IN terminals Used to connect devices equipped with BALANCED XLR output terminals. (v p. 66) Settings Tips Appendix N FLASHER IN jack Used when using a control BOX or other such control devices to control this unit. O REMOTE CONTROL jacks Used to connect infrared receivers/transmitters in order to operate this unit and external devices from a different room. (v p. 79) P Digital audio connectors (DIGITAL AUDIO) Used to connect devices equipped with digital audio connectors. (v p. 45) Q Balanced XLR OUT terminals Used to connect a power amp with BALANCED XLR input terminals. (v p. 44) R DC OUT jack Used to connect devices equipped with the trigger function. (v p. 81) S RS-232C connector Used to connect home automation controller devices fitted with RS-232C connectors. Consult the owner's manual of the home automation controller for more information about serial control of this unit. Perform the operation below beforehand. A Turn on the power of this unit. B Turn off the power of this unit from the external controller. C Check that the unit is in the standby mode. NOTE Do not touch the inner pins of the connectors on the rear panel. Electrostatic discharge may cause permanent damage to the unit. Front panel Display Rear panel 28 Remote Index