Marantz ER2500 User Guide - Page 14

ENGLISH 4 5 6 7 8 9 STEREO DISPLAY TV-CH SCANNING THE CODE TABLE0 VOLUME SURROUND MUTE 4 7 STEREO CHECKING THE CODE SURROUND 5 6 8 9 DISPLAY 0 VOLUME TV-CH MUTE SYSTEM SOURCE 2 DVD TUNER TV TV POWER VCR AMP SLEEP TV-INPUT 1 4 7 STEREO SURROUND 2 3 TV-VOL 5 6 8 9 DISPLAY 0 VOLUME TV-CH MUTE 3 DVD-SET UP TOP MENU ENTER 2,5 RETURN MENU PRESET TUNE S.TITLE AUDIO ANGLE ZOOM MODE RDS PTY CLR SET UP ROOM SET SPK SET TIMER CLOCK A/D T.TONE S.WOOFER NIGHT B-BOOST SYSTEM SOURCE 1 1 DVD TUNER TV TV POWER VCR AMP SLEEP TV-INPUT 1 2 3 TV-VOL 4 5 6 7 8 9 STEREO DISPLAY TV-CH 0 SURROUND VOLUME MUTE 2 DVD-SET UP TOP MENU ENTER RETURN MENU PRESET TUNE S.TITLE AUDIO ANGLE ZOOM MODE RDS PTY CLR SET UP ROOM SET SPK SET TIMER CLOCK A/D T.TONE S.WOOFER NIGHT B-BOOST Once you have found and the codes for your various appliances, you may want to write them down here. TV DVD-SET UP TOP MENU RC2400SR ENTER 1. Turn RETURN on the aMENpU pliance which should be controlled. 2. Press PRESET and hold down the ENTER button and press TV button until the indicator lamp blinks TUNE twice. S.TITLE AUDIO ANGLE ZOOM 3. Aim the remote control sensor at the appliance MODE RDS PTY CLR and slowly pressing the cursor (3,4) button SET UP ROOM SET SPK SET TIMER CLOCK until appliance turns off. • If the cursor A/D T.TONE S.WOOFER NIGHT B-BOOST (3,4) button is not pressed with 10 seconds, this programming function is canceled. RC2400SR 4. Stop when the appliance turns off. 5. Press ENTER button once to lock in the code. At this time, the indicator lamp will blink twice. DVD-SET UP TOP MENU RC2400SR ENTER 1. Press RETURN and hold MENU down the ENTER button and press PRESET TV button until the indicator lamp blinks twice. TUNE 2. Press the DISPLAY button. S.TITLE AUDIO ANGLE ZOOM The indicator will blink twice. MODE RDS PTY CLR 3. After 2 seconds, the indicator will blink according SET UP ROOM SET SPK SET TIMER CLOCK to first, second and third digit for the current setup code, count A/D T.TONE S.WOOFER NIGHT B-BOOST the indicator blinks (e.g. 3 blinks = 3) and write down the number. Note: RC2400SR • If a code digit is "0", the indicator will blinks 10 times. 10