Marantz PM-14S1 HDAM & Current feedback Amp of Marantz Unique technolo - Page 23

Switching the illumination lamp setting The illumination lamps on the both sides of the unit main panel can be turned on or off. • The illumination lamp is set to on in the factory default settings. Setting the Auto Standby mode You can set the unit to automatically switch to standby mode if the unit is not operated for 30 minutes when there is no audio input. Auto Standby mode is set to on by default. Turning Auto Standby mode off Turning the illumination lamp off Press and hold DISPLAY on the unit for 2 seconds or longer. The illumination lamps turn off. Press and hold TONE on this unit for 5 seconds or longer. "AUTO STBY OFF" appears on the display. Turning Auto Standby mode on Turning the illumination lamp on Press and hold DISPLAY on the unit for 2 seconds or longer. The illumination lamps light. Press and hold TONE on this unit for 5 seconds or longer. "AUTO STBY ON" appears on the display. • This unit will automatically enter standby mode after about continuous 30 minutes in the following conditions. • No operation performed on the remote control. • No operation of this unit. • The display will show the remaining time for three minutes before the units enters standby mode. • In F.C.B.S. connection, only the ID 1 master unit activates Auto Standby mode. If the ID 1 master unit is operated with no audio input, set the Auto Standby mode to off. ENGLISH 19 Appendix Tips Settings Playback Connections Preparation