Marantz RC1200 User Guide - Page 31

CLONE, RX OK, RX NG, Cursor button

Get Marantz RC1200 PDF manuals and user guides View all Marantz RC1200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

ENGLISH 3. Use a ballpoint pen or other sharp point to press the MODE button z on the receiving unit to call up the CLONE and RX displays. CLONE appears at LCD A and RX at LCD B. POWER SOURCE ON ON / OFF OFF LEARNING REMOTE CONTROL RC 1200 MACRO MODE 4. Press the OK Cursor button ⁄0 on the receiving unit. 5. Press the OK Cursor button ⁄0 on the sending unit. The copying operation is now commenced. CH OK VOL 6. During the copying operation, the bar displays at LCD C on both units start moving from left to right. After the entire bar displays have lighted, the display at LCD B on the receiving unit changes to RX OK and the LCD display on the sending unit changes to TX OK. Copying is now completed. • Do not touch either of the remote controllers during the copying operation. Doing so may cause copying to fail. • When copying has failed at an interim point, RX NG will appear on the LCD display of the receiving unit. Check steps 1 to 5, and repeat. 

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
30
ENGLISH
ON
OFF
ON / OFF
SOURCE
MACRO
MODE
LEARNING
REMOTE
CONTROL
RC
1200
POWER
CH
VOL
OK
OK
3.
Use a ballpoint pen or other sharp point to
press the
MODE
button
z
on the
receiving unit to call up the
CLONE
and
RX
displays.
CLONE
appears at LCD
A
and
RX
at LCD
B
.
4.
Press the
OK
Cursor button
⁄
0
on the receiving
unit.
5.
Press the
OK
Cursor button
⁄
0
on the sending
unit.
The copying operation is now
commenced.
6.
During the copying operation, the bar
displays at LCD
C
on both units start
moving from left to right.
After the entire
bar displays have lighted, the display at
LCD
B
on the receiving unit changes to
RX OK
and the LCD display on the
sending unit changes to
TX OK
.
Copying
is now completed.
• Do not touch either of the remote
controllers during the copying
operation.
Doing so may cause
copying to fail.
•
When copying has failed at an interim
point,
RX NG
will appear on the LCD
display of the receiving unit.
Check
steps 1 to 5, and repeat.