Marantz SD4050 SD4050 User Guide - Page 8

ENGLISH FRANÇAIS AUTOMATIC TAPE SELECTION This Stereo Cassette Deck contains an automatic tape selector which automatically selects the optimum bias and equalization for the tape in use. This is accomplished by detection of tape type detection holes in the cassette housing. ¼ If a tape without tape type detection holes is used, the deck will be set for normal tapes. PLAYBACK ¼ The operations described below apply to deck A and deck B alike. ¼ Switch on your amplifier or receiver. ¼ Set the Function Selector on your amplifier or receiver to the TAPE or Tape monitor position. ¼ The numbers in the illustration below depict the order in which operation steps are carried out. re Detection holes for metal tape Detection holes for chrome tape DOLBY NR C B OFF TIMER REC OFF PLAY REV. MODE CCONT. PLAY DOUBLE CASSETTE DECK SD4050 COUNTER RESET COUNTER RESET DUBBING SPEED SYNC REV NORMAL HIGH REC LEVEL RECORD PAUSE REC MUTE AUTO REVERSE AUTO TAPE SELECT/HIGH SPEED DUBBING STOP PLAY POWER ON/OFF A PLAY EJECT STOP PLAY AUTO REVERSE AUTO TAPE SELECT/HIGH SPEED DUBBING MIN MAX PITCH CONTROL - PHONES + EJECT BREC/PLAY tq uw y 1. Press the POWER switch q to the ON ( ) position. 2. Press the EJECT ( ) button w to open the cassette compartment cover e. 3. Load the cassette tape and close the cassette compartment cover e. 4. When listening to a tape that has been recorded with Dolby noise reduction, set the DOLBY NR switch r to match the system used at the time of recording. DOLBY NR C B OFF 5. Select the type of tape transport with the REV MODE switch t. REV. MODE 6. Press the PLAY button y ( or ) to being playback. Transport Direction Forward Reverse Indicator 7. Press the STOP ( ) button u to stop the playback. ¼ In the continuous playback mode (REV MODE set to ), playback of both tape sides will be repeated 5 times and then stop automatically. ¼ If different types of Dolby noise reduction are used for record and playback, playback response will be adversely effected. ¼ When power is turned off during tape transport, it may not be possible to remove the cassette by pressing the EJECT ( ) button. In this case, turn on power again before you press the EJECT ( )button. Mode To listen to one side only To listen to playback of both sides To listen to continuous play back of both sides and both decks. Switch position 8