Marantz SR6003 SR6003 User Manual - English - Page 15
Connecting Audio Components
View all Marantz SR6003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
NAMES AND FUNCTION BASIC CONNECTIONS BASIC OPERATION ENGLISH CONNECTING AUDIO COMPONENTS CD recorder OUT IN DIGITAL DIGITAL L L INPUT OUTPUT R R OUT IN L L R R LR LR Tape Deck L R R L LR LR FM (75Ω) GND AM ANTENNA INPUT 1(TV) INPUT 2(DVD) INPUT 3(VCR) OUTPUT 1 OUTPUT 2 L SL C SBL ZONE A TV DVD L VCR DSS R R (AUX 2) SR SW 7.1CH INPUT SBR RS-232C SPEAKER C OFF ON OUT IN OUT TAPE IN OUT VIDEO INPUT 1(TV) S-VIDEO AUDIO CD/CDR TV(1) 4 DVD(2) VCR IN(3) VCR OUT DSS(4) MONITOR OUT Y CB/PB CR/PR DIGITAL IN DIGITAL FLASHER IN REMOTE CONT. REC/ZONE B INPUT 2(DVD) SIRIUS IN 5 IN OUT 1 2 3 OUT DC OUT OUT AC OUTLETS 120V 60Hz L SL C SBL R L R L R L R L UNSWITCHED 1.25A 150W FRONT A FRONT B SURROUND R SR SW SBR FRONT A OR B,CENTER, SURR,SURR BACK : 6-8 OHMS FRONT A + B : 8 OHMS SPEAKER SYSTEMS PRE OUT CENTER SURROUND BACK SPEAKER C/ ZONE SPEAKER A SWITCHED 1.25A 150W AC IN RL RL The output audio signal from the TAPE OUT jack and the CD/CD RECORDER OUT jack is the same signal which is currently selected. Caution: • Do not connect this unit and other components to mains power until all connections between components have been completed. Notes: • Insert all plugs and connectors securely. Incomplete connections may make noise. • Be sure to connect the left and right channels properly. Red connectors are for the R (right) channel, and white connectors are for the L (left) channel. • Be sure to connect input and output properly. • Refer to the instructions for each component that is connected to this unit. • Do not bind audio/video connection cables with power cables and speaker cables this will result in generating a hum or other noise. CONNECTING DIGITAL AUDIO COMPONENTS • There are 5 digital inputs, 2 coaxial jacks and 3 optical jacks, on the rear panel. You can use these jacks to input PCM, Dolby Digital and DTS bitstream signals from a CD, DVD, or other digital source components. • There is one optical output jack on the rear panel. This jack can be connected to a CD recorder or a MD recorder input.When you use this jack as ZONE B, you cannot use it as recording output. (See page 9, 38) • Refer to the instructions for each component. To setup the digital audio format of DVD player, or other digital source's connected to digital input jacks. • Use fiber optical cables (optical) for DIG-1,2,3 input jacks and REC/ZONE B output jack. Use 75 ohms coaxial cables (for digital audio or video) for DIG-4, 5 input jacks. • You can designate the input for each digital input/ output jacks according to your component. (See page 27) Notes: • The digital signal jacks on this unit conform to the EIA standard. If you use a cable that does not conform to this standard, this unit may not function properly. • Each type of audio jack works independently. Signals input through the digital and analog jacks are output through the corresponding digital and analog jacks, respectively. LR Analog Audio Digital Audio (coaxial) Digital Audio (optical) ADVANCED CONNECTIONS SETUP ADVANCED OPERATION TROUBLESHOOTING OTHERS 12