Marantz SR8300 User Guide - Page 27
Connecting Speakers
View all Marantz SR8300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
ENGLISH CONNECTING SPEAKERS SURROUND BACK RIGHT LEFT DIRECT INPUT L R LEVEL R L MIN MAX MIN MAX VARIABLE THRU INPUT OUTPUT L R A A R L B B SPEAKER SYSTEMS IN OUT REMOTE CONTROL POWER AMPLIFIER FRONT SM6100 RIGHT LEFT CENTER DIGITAL-OUT OPT COAX PRE OUT 1 L 2 R 3 C GND ANTENNA GND AM MULTI VIDEO OUT RS232C EXT. IR OUT DC OUT 1 DC OUT 2 IN MULTI RC OUT RC-5 SW 4 SL 5 SR 6 SBL SBR MULTI OUT R FRONT L CD SURR. SURR. BACK IN TAPE OUT IN S.W CD-R CENTER /MD OUT DIGITAL-IN R L 7.1CH-IN R AUDIO L R L MONI. 2 MONI. 1 DVD MODEL NO.SR8300 Y CB MONITOR OUT CR DSS Y TV IN VCR1 OUT CB DSS IN CR Y IN VCR2/ DVD-R OUT CB DVD IN CR VIDEO S-VIDEO COMPONENT VIDEO - + FRONT LEFT FRONT RIGHT SURR. BACK - + MULTI ROOM LEFT MULTI ROOM RIGHT CENTER SPEAKER SYSTEMS 6-8 OHMS SWITCHED 120W 1A SURR. LEFT SURR. RIGHT UNSWITCHED 120W 1A AC OUTLETS 120V 60HZ AC IN PASSIVE SUBWOOFER ACTIVE SUBWOOFER or INVERT OUTPUT INPUT INPUT LEVEL BTL EXT. CONT. IN MASTER SLAVE REMOTE CONT. MIN MAX VIDEO/ SYSTEM OUT OUT IN +5~13V DC FUSE POWER SPEAKER SYSTEM MINIMUM 4 OHMS AMPLIFIER MA700 SURROUND BACK RIGHT LEFT SURROUND CONNECTING SPEAKER WIRE 1. Strip away approx. 3/8 inch (10 mm) of wire insulation. 2. Twist the bared wire ends tight to prevent short circuits. 3. Loosen the knob by turning counterclockwise. 4. Insert the bare part of the wire into the hole in the side of each terminal. 5. Tighten the knob by turning clockwise to secure the wire. 1. 2. 3/8 inch (10 mm) 3. 4. 5. CONNECTING BANANA PLUG Banana plug connections are also possible. Tighten the knob by turning clockwise and then insert the banana plug. Caution: • Be sure to use speakers with the specified impedance shown on the rear panel of this unit. • To prevent damage to circuitry, do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. • Do not touch the speaker terminals when the power is on. It may cause electric shocks. • Do not connect more than one speaker cable to one speaker terminal. Doing so may damage this unit. Note: • Be sure to connect the positive and negative cables for the speaker properly. If they are miss-connected, the signal phase will reversed and the signal quality will be corrupted. CONNECTING A SUBWOOFER Use the PRE OUT SUBWOOFER jack to connect a powered subwoofer (power amplifier built in ). If your subwoofer is passive type (power amplifier is not built in), connect a monaural power amplifier to the PRE OUT SUBWOOFER jack and connect the subwoofer to the amplifier. 23