Marantz SR9600XM SR9600XM User Manual - Page 3

ENGLISH LISTENING TO XM SATELLITE RADIO SELECTING AN INPUT SOURCE Before you can listen to XM Satellite Radio, you must first select the input source on the SR9600. 1. AV SURROUND RECEIVER SR9600 wed Jun 01 4:40pm 1/8 A/V Amp Source Select INPUT SELECTOR VOLUME STANDBY POWER ON/STANDBY PHONES PURE DIRECT THX DOWN TUNING UP BAND F/P SURROUND MODE AUTO MULTI MULTI SPEAKER AUTO TUNE T-MODE MEMORY CLEAR PURE DIRECT THX 7.1CH INPUT MENU ENTER DISPLAY EXIT MRAC SPEAKERS A/B MIC DOWN UP DIGITAL AUX 1 INPUT S-VIDEO VIDEO L AUDIO R 1. 1. Select "XM" by turning the INPUT SELECTOR knob on the front panel. Or, tap the "XM" on the remote control unit. CHECKING THE XM SIGNAL STRENGTH AND RADIO ID wed Jun 01 4:40pm 1/2 XM XM : Main 1. SIGNAL : STRONG SIGNAL : MARGINAL Signal strength is good Signal strength is marginal SIGNAL : WEAK SIGNAL : NON Signal strength is poor Loss of the signal 2. Adjust the antenna location until Signal strength is good. 3. Turn the GYRO TUNING dial or tap the channel or button on the remote control unit to select channel 0 (XM000). • The Radio ID is displayed. Radio ID Note: • If "CHECK ANTENNA" appears in the front panel display, the XM Connect-and-Play antenna may not be connected to the XM terminal on the rear panel of this unit properly. SWITCHING XM INFORMATION IN THE FRONT PANEL DISPLAY You can display XM information (such as artist name, song title, category or signal status) for the channel currently selected in the front panel display. wed Jun 01 4:40pm 1/2 XM XM : Main 1. 1. Tap the Disp. button on the remote control unit repeatedly to toggle between the following channel information display modes. Artist name/Song title Channel category Signal Status Surround mode (OSD ON) When the channel Artist name/Song title is displayed: When the Surround mode is displayed: The video monitor output will show OSD information. XM I N FORMA T I ON XM CHAN NAME T I TLE CAT : 040 : DeepT r acks :P i nk F l o i d : Mo n e y : Roc k S I GNAL : S TRONG Note: • The front panel display can indicate up to 20 alphanumeric characters at once. If the information contains more than 20 characters, the information scrolls from right to left. • If the information contains a character that cannot be recognized by that unit, the character will be displayed with " " (space). 1. Tap the Disp. twice on the remote control unit. Signal status is displayed. DIGITAL • The display changes as shown below according to the receiving condition. When the channel category is displayed: When the signal status is displayed: 3