Maytag MDB5601AWW User Manual - Page 12

Cycles, Options and Lights Lights/Display (select models) INDICATOR DESCRIPTION Time Remaining Display (select models) Shows approximate minutes remaining in a cycle. The symbol "2H" will appear when cycle time is greater than 99 minutes. Cycle times shown in the numerical display (select models) will increase or decrease, based on each load's soil level, water temperature and selected options. Clean Light Drying Light (select models) Illuminates at the end of the cycle and remains lit until the door has been open for 30 seconds continuously. Illuminates during the entire dry period and goes out when the cycle is completed. Washing Light (select models) Illuminates during all rinse and wash portions of the cycle. Heating Delay Light Illuminates when cycle is being extended to heat the water. (select models) Sanitized Light (select models) Illuminates at the end of the cycle when conditions have been met to achieve sanitization. The light will remain lit until the door has been open for 30 seconds continuously. Notes • When Sanitize is selected, cycles are monitored to assure sanitization. The Sanitized light will not activate if sanitization requirements are not met. This could happen if the cycle is interrupted, power failure occurs or incoming water temperature is below 120° F (49° F). • The Clean and Sanitized indicator lights (select models) will not relight after a power failure until after the next cycle is run. 11