Maytag MDD8000AWS Owners Manual - Page 5

CYCLE SELECTIONS CYCLES DISH LOAD TYPES DESCRIPTIONS Use to quickly wash prerinsed glasses or dish loads. This cycle does not dry. WASH TIME (HH:MM) Cycle Cycle + Options *Maximum Minimum Minimum 0:30 none none You can customize your cycle by selecting an option. See option selections. If you change your mind, press the option again to turn off the option, or select a different option. You can change an option anytime before the selected option begins. *Maximum wash times depend on water temperature, heavy soil condition, dish load size and options selected. NOTE: Dry time (fan running) is typically 4 hours after wash cycle. After 30 minutes of dry time, the clean light will illuminate. Anytime after the clean light is lit and the drawer is opened for longer than 30 seconds, the cycle will be terminated. OPTION SELECTIONS OPTIONS DISH LOAD TYPES Loads containing tough, baked-on food. DESCRIPTIONS Increases the target water temperature during the wash portions of the cycle. Adds heat, wash time and water to the cycle. USE WITH: Sensor Wash, Heavy Duty or Normal Wash To run your dishwasher at a later time or during offpeak hours. Delays the start of a cycle up to 6 hours. Select a wash cycle and options. Press 6 Hour Delay. Press START/RESUME. Close the drawer firmly. All cycles, except Rinse Only Control Lock To avoid unintended use of your dishwasher, or cycle and option changes during a cycle. To turn on Lock, press and hold Control Lock for at least 3 seconds. To turn off Lock, press and hold Control Lock for at least 3 seconds. When Control Lock is lit, all buttons are disabled. If you press any pad while your dishwasher is locked, the light flashes 3 times. The dishwasher drawer can be opened while the controls are locked. Anytime IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically compensate by adding time, heat and water as needed. CONTROLS AND CYCLE STATUS CONTROL PURPOSE To start or resume a wash cycle COMMENTS If the drawer is opened during a cycle, a delay, or the power is interrupted, the Start/Resume indicator flashes. To restart the drawer, open the drawer, press Start/Resume and close the drawer firmly within 4 seconds. To cancel wash cycle Close the drawer firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher drain completely. If the Cancel button is pressed a second time, the drawer will turn off. To follow the progress and status of your dishwasher cycle Clean indicator glows when a cycle is finished. Rinse aid low indicator light glows when the rinse aid dispenser needs to be refilled. 5