Maytag MDD8000AWS Owners Manual - Page 6

Removable Rack Insert Each drawer has one removable rack insert which allows you to adjust the rack to the type of load you are washing. B Dishwasher Features Your Maytag dishwasher may have some or all of these features. Turning off the Rinse Aid Low Indicator light: To turn off the Rinse Aid Low indicator light, set the Rinse Aid Dispenser level to "0." See "Rinse Aid Adjustment Mode." To deactivate the tones, see "Tone Options Adjustment Mode." A If the Child Lock feature has been set, deactivate during the Sabbath or holidays. A. Large insert B. Base rack To return to normal operation: To reactivate your desired rinse aid level, see "Rinse Aid Adjustment Mode." To reactivate your desired tones, see "Tone Option Adjustment Mode." NOTES: ■ If needed, be sure to allow enough time to run a cleaning cycle prior to the start of the Sabbath. ■ Clean dishes should be unloaded from the drawer dishwasher prior to setting the controls for the Sabbath to avoid activation of the indicator lights. To install rack insert: 1. Place the insert end legs under the back base rack wire. 2. Gently push down on the insert rack handle until the insert locks into position. To remove rack insert: Gently pull in and up on the handle to release the insert handle from the base rack. Sabbath Guidelines (on some models) For those who observe kosher dietary guidelines, Star-K has certified that the drawers in the 2-drawer model are separate and therefore one drawer can be designated to wash utensils used for dairy, while the other can be designated for washing meat utensils. However, neither drawer can be used to wash dishes on the Sabbath or holidays. Storage of dishes Although washing of dishes with the drawer dishwasher is not permitted on the Sabbath or on holidays, storage of dishes is possible by following the guidelines listed below. IMPORTANT: Care should be taken when opening the drawer(s) and loading dishes while in the disabled mode as an unintended key press could activate the indicator lights. Rinse Aid Adjustment Mode NOTE: The rinse aid cannot be adjusted while a cycle is running. To enter the Rinse Aid Adjustment Mode: 1. Press and hold the High Temp Wash option pad for 3 seconds. A tone will sound to indicate you have entered the Rinse Aid Adjustment Mode. 2. The rinse aid dispenser has 4 settings. "0" is the lowest with no rinse aid being dispensed and "3" the highest setting. With each consecutive press of the High Temp Wash option pad, the amount of rinse aid being dispensed into the dishwasher drawers increases. 3. Cycle lights illuminate with each touch of the High Temp Wash option to indicate which rinse aid level is selected. See table. RINSE AID DISPENSER LEVEL 0 OFF OFF OFF 1 ON OFF OFF 2 ON ON OFF 3 ON ON ON NOTE: A rinse aid dispenser level of "0" disables the Rinse-Aid Low indicator light. To exit the Rinse Aid Adjustment Mode: Press any key other than High Temp Wash to exit the Rinse Aid Adjustment Mode. Tone Option Adjustment Mode 1. Press and hold the High Temp Wash option pad for 3 seconds. A tone will sound to indicate you have entered the Tone Option Adjustment Mode. 2. To change the tone options, press the 6-Hour Delay option pad. 6