Maytag MED5630H Installation Instructions - Page 26

Remove rotating assembly, Reinstall hinge assembly on opposite side, Reposition rotating assembly,

Get Maytag MED5630H PDF manuals and user guides View all Maytag MED5630H manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

8. Reinstall hinge assembly on opposite side 10. R eposition rotating assembly and tubing Flip over the inner door to the left. Using a T20® screwdriver, reinstall the hinge assembly on the opposite side from which it was removed. DOORS WITH ELECTRICAL WIRING: 9. Remove rotating assembly Reposition rotating assembly and tubing 180° to opposite side of the door. 11. Rotate assembly bottom and fasten in place Press tubing into indents. Lift off inner door assembly. Using a Phillips screwdriver, remove the two screws securing the rotating assembly to the door. Rotate bottom of assembly 180° towards you and secure assembly with the two screws removed earlier, using a Phillips screwdriver. Press tubing into indents. IMPORTANT: Make sure to swing hinge down in front of rotating assembly (see Step 12). 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
26
Flip over the inner door to the left. Using a T20
®
screwdriver,
reinstall the hinge assembly on the opposite side from which it
was removed.
DOORS WITH ELECTRICAL WIRING:
Lift off inner door assembly. Using a Phillips screwdriver, remove
the two screws securing the rotating assembly to the door.
Reposition rotating assembly and tubing 180° to opposite side of
the door.
Rotate bottom of assembly 180° towards you and secure
assembly with the two screws removed earlier, using a Phillips
screwdriver. Press tubing into indents.
IMPORTANT:
Make sure to swing hinge down in front of rotating
assembly (see Step 12).
9.
Remove rotating assembly
8.
Reinstall hinge assembly on opposite side
10.
Reposition rotating assembly
and tubing
11.
Rotate assembly bottom and fasten
in place
Press tubing
into indents.