Maytag MED6630HW Installation Instructions - Page 24

DOOR REVERSAL (OPTIONAL) The following instructions are for models with round and square-shaped doors. Tools needed: ALL DOORS: 2. Remove door from dryer Min. 8" (203 mm) long TORX®, T20®, and T25®† screwdrivers #2 Phillips screwdriver REVERSE DOOR SWING: ROUND-SHAPED DOOR DOORS WITH ELECTRICAL WIRING: WARNING IMPORTANT: If the protective film has not yet been removed from the dryer, peel the film from the dryer door before proceeding. Using a T25® screwdriver, remove the four screws securing the door hinge to the dryer and lift the door up and out to remove. Place the door on a soft towel or other non-scratch surface. Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 3. Move the door strike 1. Disconnect wiring from door Using a T25® screwdriver, remove the two screws securing the door strike to the door frame of the dryer. Rotate the strike 180° and attach to the opposite side of dryer door frame with the two screws removed earlier, as shown. Using a Phillips screwdriver, remove middle screw in hinge. Disconnect wiring. Tuck wiring into opening. †®TORX, T20, and T25 are registered trademarks of Acument Intellectual Properties, LLC. 24