Maytag MEDB955F Door Reversal Guide - Page 1

DRYER DOOR REVERSAL INSTRUCTIONS You can change your door swing from a right-side opening to a left-side opening, if desired. The following instructions are applicable for models with a side-opening door. NOTE: To complete the door swing reversal exactly as seen in these instructions, a door reversal kit must be purchased. For ordering information, please visit the manufacturer's website or reference the contact information listed on your Quick Start Guide. Tools Needed Plastic putty knife Minimum 8" (203 mm) long TORX® T20® star driver WARNING #2 Phillips screwdriver Optional assembly kit covers 3. Remove hinge screws Using a T20® star driver, remove screws (A) and then screws (B) from each of the two hinges attaching the dryer door to the front panel of the dryer. Set the hinge screws off to the side for use in reinstalling the door. Electrical Shock Hazard Disconnect power before removing doors. Failure to do so could result in death or electrical shock. 1. Place towel on flat workspace Place a towel or soft cloth on a flat workspace, such as the top of the dryer or the floor, to avoid damaging the dryer's surface or the dryer door. 4. Remove door from cabinet Remove the dryer door from the cabinet by lifting upward and out. Lay the door on the towel or soft cloth you placed on a flat workspace. 2. Remove hinge covers from dryer Open the dryer door. Use a plastic putty knife to remove the hinge covers and plastic covers from the front panel of the dryer. Set them aside. 5. Remove door hinge covers Use a plastic putty knife to remove the door hinge covers. Set them aside. TORX and T20 are trademarks of Acument Intellectual Property, LLC. 1