Maytag MEDZ600TE Use and Care Manual - Page 8

Changing Cycles, Options, and Modifiers You can change Sensor Dry Cycles, Timed Dry Cycles, Options, and Modifiers, anytime before pressing START. NOTE: Three short tones sound if an unavailable combination is selected. The last selection will not be accepted. Changing Cycles after pressing START 1. Press PAUSE/CANCEL twice. This ends the current cycle. 2. Select the desired cycle and options. 3. Press and hold START. The dryer starts at the beginning of the new cycle. NOTE: If you do not press START within 5 minutes of selecting the cycle, the dryer automatically shuts off. Changing Options and Modifiers after pressing Start You can change an Option or Modifier anytime before the selected feature begins. 1. Press PAUSE/CANCEL once. 2. Select the new feature. 3. Press and hold START to continue the cycle. NOTE: If you happen to press PAUSE/CANCEL twice, the program clears and your dryer shuts down. Restart the selection process. Drying Rack Option Use the drying rack to dry items such as sweaters and pillows without tumbling. The drum turns, but the rack does not move. If your model does not have a drying rack, you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer. NOTE: The drying rack must be removed for normal tumbling. Do not use Sensor Dry cycles with the drying rack. To use the drying rack Do not remove the lint screen. 1. Open dryer door. A A. Front edge 2. Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure over the lint screen. B 3. Put the wet items on top of the drying rack. Leave space between the items so air can reach all the surfaces. NOTE: Do not allow items to hang over the edge of the drying rack. 4. Close the door. 5. Press the POWER button. 6. Select a Timed Dry Cycle and temperature (see following chart). Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Fluff temperature setting. 7. You may change the cycle time by pressing Timed Dry Cycle Adjust Up or Down arrow buttons. Reset time as needed to complete drying. Refer to the following table. 8. Press and hold START button (about 3 seconds). NOTE: Check the lint screen and remove any lint accumulated from items dried on the drying rack. This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold. Rack Dry Setting Temp. Time* (Minutes) Wool Sweaters Timed Low 60 Block to shape and lay flat Dry Cycle on the drying rack. Stuffed toys or pillows Timed Low 60 Cotton or polyester fiber Dry Cycle filled Stuffed toys or pillows Foam rubber filled Timed Air Fluff 90 Dry Cycle (no heat) Sneakers or canvas shoes Timed Air Fluff 90 Dry Cycle (no heat) *Reset time to complete drying, if needed. NOTE: You must remove drying rack for normal tumbling. Do not use Sensor cycles with the drying rack. A A. Drying rack front edge B. Dryer back panel 8