Maytag MFW9700S Use and Care Guide - Page 13

s Liquid detergent: Put the separator in the front position, between the guides, as shown following. There will be no gap between the bottom of the wash cycle detergent compartment and the bottom of the separator. LIQUI A SO B Separator in front position, between guides A. Separator B. Guide s Powdered detergent: Put the separator in the back position, behind the guides, as shown following. There will be a gap between the bottom of the wash cycle detergent compartment and the bottom of the separator. A LIQUI SO B Separator in back position, behind guides A. Separator B. Guide NOTE: The separator will be in the POWDER (back) position when shipped from the factory. Chlorine bleach compartment (Letter E in Dispenser Illustration) Add no more than ¹⁄₃ cup (80 mL) liquid chlorine bleach to this compartment. The bleach will be automatically diluted and dispensed at the optimum time during the first rinse after the wash cycle. This compartment cannot dilute powdered bleach. s Always measure liquid chlorine bleach. Use a measuring cup with a pour spout; do not guess. s Do not fill beyond the "MAX" level. Overfilling could cause severe garment damage. Fabric softener compartment (Letter F in Dispenser Illustration) Add ¼ cup (60 mL) liquid fabric softener to this compartment. Fabric softener will be automatically dispensed in the final rinse. s Do not fill beyond the "MAX" level. Pausing or Restarting 1. To pause the washer at any time, select PAUSE/OFF. 2. To continue the cycle, select HOLD TO START (for approximately 1 second). Changing Cycles, Options and Modifiers Not all Options and Modifiers are available with all cycles. Cycles, Options and Modifiers can be changed anytime before HOLD TO START is selected. Options and Modifiers can be changed anytime after HOLD TO START is selected and before the start of the selected Option or Modifier. To cancel a cycle and select a new cycle 1. Select PAUSE/OFF twice. 2. Select desired cycle. 3. Select the desired OPTIONS. 4. Select HOLD TO START (for approximately 1 second) to restart the washer at the beginning of the new cycle. To cancel a cycle 1. Select PAUSE/OFF twice. 2. The washer powers down, the door unlocks, and clothes can be removed. NOTE: If the water level or the temperature is too high, the washer will drain automatically before the door unlocks. To change Options or Modifiers after the cycle has started 1. Select PAUSE/OFF. 2. Select the desired OPTIONS or MODIFIERS. 3. Select HOLD TO START (for approximately 1 second) to continue the cycle. To drain the washer manually 1. Select PAUSE/OFF. 2. Select DRAIN/SPIN. 3. Select HOLD TO START (for approximately 1 second) to begin the drain. 4. When the spin is complete, the door unlocks. Items can be removed from the washer. Status Lights These lights show which portion of the cycle the washer is operating. They also indicate when you can add an additional item to the wash cycle and when the controls are locked. 13