Maytag MFX2876DRM Use & Care Guide - Page 14
Install Air Filter
View all Maytag MFX2876DRM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
4. Align the arrow on the water filter label with the cutout notch in the filter housing and insert the filter into the housing. 5. Turn the filter clockwise 90 degrees (¹⁄₄ turn), until it locks into the housing. NOTE: If the filter is not correctly locked into the housing, the water dispenser will not operate. Water will not flow from the dispenser. 6. While the compartment door is still open, lift the filter up into the compartment. Then, close the filter compartment door completely. 7. Flush the water system. See "Flushing the Water Filter" in the "Water and Ice Dispensers" section. IMPORTANT: If you do not flush the water system, you may experience dripping and/or decreased flow from the water dispenser. The Water Filter Status Light Press WATER FILTER to display the percentage of filter life remaining (from 99% to 0%). Press WATER FILTER again to return to the Normal screen. The water filter status lights will help you know when to change your water filter. ■ ORDER (yellow) - it is almost time to change the water filter. ■ REPLACE (red) - Replace the water filter. While you are dispensing water, "Replace" will blink. NOTE: If a water filter is not installed or is undetected because it is not properly installed (locked into place), "Replace" and "--% remaining" will display on the control panel. Check the water filter. ■ RESET the water filter status tracking feature. After you replace the disposable filter with a new filter, closing the filter compartment door will automatically reset the filter status tracking feature. See "Using the Controls." NOTE: "Replace" will remain illuminated if a filter is not installed or is installed incorrectly. Replace the Water Filter To purchase a replacement water filter, see "Accessories." Replace the disposable water filter when indicated on the water filter status display or at least every 6 months. If water flow to your dispenser or ice maker decreases noticeably, change the water filter sooner. 1. Locate the water filter compartment in the right-hand side of the refrigerator ceiling. Push up to release and lower the compartment door. 2. Turn the water filter counterclockwise (to the left), and pull it straight out of the compartment. NOTE: There may be some water in the filter. Some spilling may occur. Use a towel to wipe up any spills. 3. Install the replacement water filter by following steps 2 through 7 in the "Install the Water Filter" section. Install Air Filter (on some models) An air filter is 15 times more powerful than baking soda at reducing common food odors inside the refrigerator. On some models, your refrigerator's accessory packet includes an air filter, which must be installed prior to use. Installing the Air Filter Install the air filter behind the vented door, located on the rear wall near the top of the refrigerator compartment. 1. Remove the air filter from its packaging. 2. Lift open the vented door. 3. Snap the filter into place. A A. Air filter 14