Maytag MFX2876DRM Use & Care Guide - Page 28
Doors
View all Maytag MFX2876DRM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
PROBLEM POSSIBLE CAUSES SOLUTIONS Water is leaking or dripping from the dispenser system NOTE: A few drops of water after dispensing is normal. The glass was not held under the dispenser long enough. Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever. Water continues to drip The refrigerator has just been from the dispenser beyond installed. the first few drops. Flushing the water system removes the air from the lines which causes the water dispenser to drip. Flush the water system. See "Water and Ice Dispensers." The water filter was recently installed or replaced. Flushing the water system removes the air from the lines which causes the water dispenser to drip. Flush the water system. See "Water and Ice Dispensers." Water is leaking from the back of the refrigerator The water line connections were not See "Connecting the Water." fully tightened. Recently removed the doors and did See "Refrigerator Doors and Drawer." not fully tighten water line connection Water from the dispenser is Water from the dispenser is chilled to This is normal. warm 50°F (10°C). The refrigerator has just been installed. Allow 24 hours after installation for the water supply to cool completely. A large amount of water was recently Allow 3 hours for the water supply to cool completely. dispensed. Water has not been recently dispensed. The first glass of water may not be cool. Discard the first glass of water dispensed. The refrigerator is not connected to a Make sure the refrigerator is connected to a cold water pipe. cold water pipe. See "Water Supply Requirements." Doors WARNING Explosion Hazard Use nonflammable cleaner. Failure to do so can result in death, explosion, or fire. To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search for "door closing and door alignment." PROBLEM POSSIBLE CAUSES SOLUTIONS The doors will not close completely The door is blocked open. A bin or shelf is in the way. Move food packages away from door. Push bin or shelf back into the correct position. Recently installed Remove all packaging materials. The doors are difficult to open The door gaskets are dirty or sticky. Clean gaskets and contact surfaces with mild soap and warm water. Rinse and dry with soft cloth. The doors appear to be uneven The doors need to be aligned, or the See "Refrigerator Leveling, Door Closing and Alignment." refrigerator needs to be leveled. The refrigerator is unsteady The refrigerator brake feet are not or it rolls forward when snug against the floor. opening and closing doors Remove the base grille. Turn both brake feet (one on each side) clockwise, the same amount, until they are snug against the floor. See "Refrigerator Leveling, Door Closing and Alignment." 28