Maytag MGD6000AG Installation Guide - Page 4
Installation Requirements - washer
View all Maytag MGD6000AG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION REQUIREMENTS TOOLS AND PARTS Gather the required tools and parts before starting installation. Tools needed for all installations: Parts supplied (all models): Flat-blade screwdriver #2 Phillips screwdriver Leveling legs (4) Parts supplied (steam models): 1/4" and 5/16" nut driver (recommended) Level Tape measure Pliers "Y" connector Parts package is located in dryer drum. Check that all parts are included. NOTE: Do not use leveling legs supplied with dryer if installing with a pedestal or a stack kit. Parts needed: (Not supplied with dryer) ■■Vent clamps ■■Vent elbows and vent work Parts needed (steam models): Utility knife Tin snips (new vent installations) 2' (0.6 m) inlet hose 5' (1.52 m) inlet hose and rubber washer Caulking gun and compound Adjustable wrench that opens to (new vent installations) 1" (25 mm) or hex-head socket wrench Tools needed for gas installations: Additional parts may be required, depending in your installation. Check local codes. Check existing electrical supply and venting. Read "Electrical Requirements" and "Venting Requirements" before purchasing parts. Optional Equipment: (Not supplied with dryer) Refer to your "Use and Care Guide" for information about accessories available for your dryer. 8" or 10" pipe wrench 8" or 10" adjustable wrench (for gas connections) Pipe-joint compound resistant to LP gas 4