Maytag MGD8630HW Installation Instructions - Page 12
Wire Power Supply Cord Connection
View all Maytag MGD8630HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
2. Attach power supply cord to strain relief 1. Prepare to connect neutral ground wire and neutral wire Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point. If your outlet looks like this: Remove center terminal block screw (B). Remove neutral ground wire (E) from green external ground conductor screw (A). 2. Connect neutral ground wire and neutral wire Power supply cord 4-wire receptacle (NEMA Type 14-30R): Go to "4-Wire Power Supply Cord Connection" on this page. Power supply cord 3-wire receptacle (NEMA Type 10-30R): Go to "3-Wire Power Supply Cord Connection" on page 13. 4-Wire Power Supply Cord Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections. Connect neutral ground wire (E) and neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw. 3. Connect ground wire 4-wire receptacle (NEMA type 14-30R) 4 prong plug Spade terminals with upturned ends Ring terminals 12 Connect ground wire (F) (green or bare) of power supply cord under green external ground conductor screw (A). Tighten screw.