Maytag MGD8630HW Owners Manual - Page 11

5. Adjust cycle settings, if desired EXTRA POWER AirDry High : 7: . AirDry High Touch and hold START/PAUSE to begin cycle Less More Sensing Wet Damp Cool Down Check Vent Off +Steam Less More Appearance may vary. Off +Steam Sensing Wet Damp Cool Down Check Vent You may adjust different settings, depending on whether you have selected a Sensor Cycle, Timed Cycle, or Steam Cycle (on some models). See the "Cycle Guide" for detailed information. NOTE: Not all options and settings are available with all cycles. Not all cycles are on all models. Sensor Cycles: The temperature may be changed by touching Temp until the desired dry temperature is lit. Once a cycle has started, the temperature can be changed within the first 5-8 minutes. You can select a different dryness level, depending on your load. Touch DRYNESS to scroll from Less to More to automatically adjust the dryness level at which the dryer will shut off. Once a dryness level is set, it cannot be changed without stopping the cycle. Sensor Cycles give the best drying in the shortest time. Drying time varies based on fabric type, load size, and dryness setting. Drying time is estimated and may change throughout the cycle. Drying time cannot be changed on Sensor Cycles. Timed Cycles: When you select a Timed Cycle, the time appears in the display. Touch MORE TIME AirDry High or LESS TIME to increase or decrease the Less More time in 5-minute increments. Sensing Wet Damp Cool Down Check Vent Off +Steam The temperature may be changed by touching Temp until the desired dry temperature is lit. Once a cycle has started, the temperature can be changed at any time unless AirDry is selected; if AirDry is selected, touch POWER/CANCEL to cancel the cycle, reselect the desired cycle settings, and touch START/PAUSE. Steam Cycles (on some models): Select Steam Refresh to reduce odors and light wrinkles in dry loads. Do not add dryer sheets. Cycle time is estimated and may change throughout the cycle. Cycle time cannot be changed on Steam Cycles. Touch and hold START/PAUSE until the display counts down "3-2-1" and the dryer starts. 8. Remove garments promptly after cycle is finished Appearance may vary. Promptly remove garments after cycle has completed to reduce wrinkling. If you will be unable to remove the load promptly, select the Wrinkle Prevent option. 6. : Select any AairDryddiHtighional options Less More Off +Steam Sensing Wet Damp Cool Down Check Vent Appearance may vary. Add additional options by touching that option. If you will be unable to remove the load promptly, select the Wrinkle Prevent option before touching Start/Pause. NOTE: Not all options and settings are available with all cycles. 11