Maytag MGDB725BW Installation Guide - Page 4

INSTALLATION REQUIREMENTS TOOLS AND PARTS Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed for all installations: Tools needed for gas installations: 8" (203 mm) or 10" (254 mm) pipe wrench 8" (203 mm) or 10" (254 mm) adjustable wrench (for gas connections) Flat-blade screwdriver Adjustable wrench that opens to 1" (25 mm) or hex-head socket wrench Level Vent clamps Pipe-joint compound resistant to LP gas Parts supplied (all models): Utility knife Caulking gun and compound (for installing new exhaust vent) Leveling legs (4) for models with riser Leveling legs (4) for models without riser Parts supplied (steam models): Tin snips (new vent installations) 1/4"( 6 mm) nut driver (recommended) Tape measure Pliers 4 "Y" connector 2' (0.6 m) inlet hose 5' (1.52 m) Inlet Hose Rubber washer Remove parts package from dryer drum. Check that all parts are included. Parts needed: (Not supplied with dryer) Check local codes. Check existing electrical supply and venting. See "Electrical Requirements" and "Venting Requirements" before purchasing parts. Mobile home installations require metal exhaust system hardware available for purchase from the dealer from whom you purchased your dryer. For further information, please refer to the "Assistance or Service" section in your "Use and Care Guide." Optional Equipment: (Not supplied with dryer) Refer to your "Use and Care Guide" for information about accessories available for your dryer.