Maytag MGR7662WS Installation Instructions - Page 11

Check Operation of Oven Broil Burner 1. Close the oven door. 2. Press the BROIL pad. 3. Press the START pad. The oven burner should light within 8 seconds. Under certain conditions, it may take the burner up to 50 to 60 seconds to light. Refer to the Use and Care Guide for proper operation of the oven controls. Adjust Oven Broil Burner Flame (if needed) Look through oven window to check broil burner for proper flame. This flame should have a ½" (1.3 cm) long inner cone of bluish-green, with an outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should be present. If flame needs to be adjusted: 1. Loosen the lock screw on the air shutter located at the rear of the broil burner. 2. Adjust the air shutter as needed. 3. Tighten lock screw. 2. Insert a flat-blade screwdriver through the opening in the side of the storage drawer, placing the screwdriver tip on the outside of the drawer clip. A A. Drawer clip 3. Depress the drawer clip by pressing the screwdriver handle toward the side of the storage drawer. A B A. Lock screw B. Air shutter 4. Press CANCEL/OFF when finished. Replace Oven Racks and Warming Drawer Replace oven racks in oven cavity. Replace warming drawer. To Replace Warming Drawer: 1. Insert warming drawer into slide rails on sides of drawer opening. 2. Lift front of drawer slightly and push firmly to close drawer. Storage Drawer The storage drawer can be removed. Before removing, check that the storage drawer is cool and empty. A flat-blade screwdriver will be needed for removal. To Remove: 1. Pull the storage drawer forward to the drawer stop. Push the drawer back approximately 1" (2.5 cm). It will be necessary to disengage the storage drawer one side at a time. A A. Drawer clip - view from outside of storage drawer 4. Gently pull forward on the storage drawer until the depressed clip clears the drawer glide. 5. Repeat steps 2-4 for the other side of the storage drawer. 6. Lift up the back of the storage drawer and remove. To Replace: 1. Lift up the back of the storage drawer and place it inside the range in its fully forward position. 2. Lift up the front of the storage drawer to a level position. 3. Slowly push the storage drawer into the range until the drawer side rails engage with the gap in the drawer glides. A A. Engage drawer glide. 4. Once the storage drawer is fully engaged on both sides, slide the drawer back into the closed position. 5. NOTE: When you are removing and replacing the storage drawer, a slight push may be needed to move the drawer stop notch past the drawer glides. 11