Maytag MMMF6030P Owners Manual - Page 12
Drill holes in Upper Cabinet, Drill holes in Rear Wall
![]() |
View all Maytag MMMF6030P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
5. Using the bottom edge of the cardboard plate across the two small lines, draw a mounting plate bottom line. 3. Using a keyhole saw, cut out the rectangular roof venting cutout area. Skip this step if for recirculation venting or wall venting installation. A B C A. Two Small Lines B. Cardboard Plate Bottom Line C. Bottom Edge of Mounting Plate 6. Draw four small circuit along with A & B & H & J holes. A A. Roof Venting Cutout Area Drill holes in Rear Wall 1. The mounting plate is located inside the inner foam in the cavity, take it out. The mounting plate is folded, open it to 180 degree at plate. A & B & H & J holes Drill holes in Upper Cabinet 1. Using a drill, cut out the power cord hole (A). 2. Drill two mounting nut holes (B), which are 3/8" (10 mm) holes at points "D" and "E" on the cardboard template. These are for two 1/4-20 x 3" bolts and washers used to secure the microwave oven to the upper cabinet. B 2. Attach the at mounting plate to wall. Make sure the 4 holes on mounting plate align with the A & B & H & J holes marked in the "Mark Rear wall" section. And the Mounting plate center markers align with the Center Mark. A A. Power Cord Hole B. Mounting Nut Holes NOTE: If upper cabinet is metal, the supply cord bushing needs to be installed around the supply cord hole as shown. B D C B E A A. Mounting Plate B. A & B & H & J holes C. Mounting Plate Bottom Line D. Center Mark E. Mounting plate center markers A A. Metal cabinet B. Power supply cord bushing 12
![](/manual_guide/products/maytag-mmmf6030p-owners-manual-9610ab4/12.png)