Maytag MVWX700AG Use & Care Guide - Page 13

TROUBLESHOOTING First try the solutions suggested here or visit our website at www.maytag.com/product_help In Canada, www.maytag.ca, for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Washer not performing as expected cont. Washer won't run or fill, washer stops working or wash light remains on (indicating that the washer was unable to fill appropriately) (cont.) Check for proper electrical supply. Plug power cord into a grounded 3 prong outlet. Do not use an extension cord. Ensure there is power to outlet. Reset a tripped circuit breaker. Replace any blown fuses. NOTE: If problems continue, contact an electrician. Normal washer operation. Lid must be closed for washer to run. Washer will pause during certain phases of cycle. Do not interrupt cycle. Washer may be stopped to reduce suds. Washer may be tightly packed. The washer senses the dry load with short spins that may take 2 to 3 minutes before water is added. You may hear the hum of the spins. This is normal. Remove several items, rearrange load evenly around the washplate. Do not load garments directly over the center of the washplate. Close lid and press START/Pause/Unlock. Add only 1 or 2 additional garments after cycle is started. Not using HE detergent or using too much HE detergent. Do not add more water to the washer. Only use HE detergent. Suds from regular detergents can slow or stop the washer. Always measure detergent and follow detergent directions based on your load requirements. To remove suds, cancel cycle. Select Rinse & Spin. Press START/ Pause/Unlock. Do not add more detergent. 13