Maytag MVWX700XL Owners Manual - Page 15

TROUBLESHOOTING First try the solutions suggested here or visit our website at www.maytag.com/help for assistance and to possibly avoid a service call. If you experience Possible Causes Washer not performing as expected (cont.) Small amount of water still in dispenser after cycle Incorrect dispenser operation Normal dispenser operation. Clogged dispensers or laundry products dispensing too soon. Residual powder in dispenser. Solution It is normal for small amounts of water to remain in dispenser. Do not overfill dispenser, which causes immediate dispensing. Always select Fabric Softener option to assure proper dispensing. Load dispensers before starting a cycle. Homes with low water pressure may result in residual powder in the dispenser. To avoid, select a warmer wash temperature if possible, depending on your load, or use liquid HE detergent. Use only liquid chlorine bleach in the bleach dispenser. In wash water temperatures colder than 60° F (15.6° C), some detergents do not dissolve well. Soils may be difficult to remove. To avoid, select a warmer wash temperature if possible, depending on your load, or use liquid HE detergent. Fabric damage No sound when buttons are pressed Odors Estimated Time Remaining is not correct Lid Locked light is flashing Sharp items were in pockets during wash cycle. Strings and straps could have tangled. Items may have been damaged before washing. Fabric damage can occur if load is tightly packed. Empty pockets, zip zippers, and snap or hook fasteners before washing to avoid snags and tears. Tie all strings and straps before starting wash load. Mend rips and broken threads in seams before washing. Load garments in loose heaps evenly around the basket wall. Load with dry items only. Use cycle designed for the fabrics being washed. Add only 1 or 2 garments after washer is started. Liquid chlorine bleach may have been Do not pour liquid chlorine bleach directly onto load. Wipe up added incorrectly. bleach spills. Undiluted bleach will damage fabrics. Do not use more than recommended by manufacturer. Do not place load items on top of bleach dispenser when loading and unloading washer. Garment care instructions may not have been followed. Button sounds are turned off. Always read and follow garment manufacturer's care label instructions. See the Cycle Guide to match your load with the best cycle. Button sounds can be turned on or off by pressing and holding Cycle Signal for 3 seconds. Monthly maintenance not done as recommended. Run the Clean Washer cycle with AFFRESH™ monthly. See "Cleaning Your Washer" in Washer Maintenance. Unload washer as soon as cycle is complete. Using wrong or too much detergent. Use only HE detergent. Be sure to measure correctly. Always follow the manufacturer's directions. Excess suds caused by not using HE detergent or using too much detergent. The lid is not closed. See "Cleaning your Washer" section. If excess suds are detected, the washer will add extra rinsing and pauses to break down suds. This will lengthen the cycle time. Use only HE detergent. Be sure to measure correctly. Close the lid. The washer will not start or fill with the lid open. A cycle was stopped or paused using the Start/Pause/Unlock button. The washer may still be spinning. The lid will not unlock until the basket has stopped spinning. This may take several minutes if washing large loads or heavy fabrics. 15