Metabo BHA 18 LTX Operating Instructions 3 - Page 11

7.6 On/Off switch, setting the speed Switching on, speed: press the trigger (9). The speed can be changed by pressing in the trigger. Switching off: release the trigger (9). 7.7 Operating mode selection Do not activate the switch button (4) unless the motor has completely stopped! Select the desired operating mode by turning the switch button (4). To turn, push in the lock (5). Drilling Hammer drilling Avoid levering with the machine when a drill bit is fitted. 7.8 Tool change with SDS chuck Before fitting, clean tool shank and apply special grease (accessories order no. 6.31800)! Use only SDS-plus tools. Inserting the tool: Turn the tool while inserting until it locks into place. The tool is locked automatically. Removing the tool: ENGLISH en E Connecting piece F Geared chuck G Twist drills for metal and wood H Screwdriver bit I Special grease (for lubricating the tool shanks) For a complete range of accessories, see www.metabo.com or the main catalogue. 10. Repairs Repairs to electrical tools must be carried out by qualified electricians ONLY! If you have Metabo electrical tools that require repairs, please contact your Metabo service centre. For addresses see www.metabo.com. You can download spare parts lists from www.metabo.com. 11. Environmental Protection Observe national regulations on environmentally compatible disposal and on the recycling of disused machines, packaging and accessories. Battery packs must not be disposed of with regular waste. Return faulty or used battery packs to your Metabo dealer! Do not allow battery packs to come into contact with water! Only for EU countries: Never dispose of power tools in your household waste! In accordance with European Guideline 2002/ 96/EC on used electronic and electric equipment and its implementation in national legal systems, used power tools must be collected separately and handed in for environmentally compatible recycling. Before disposal, discharge the battery pack in the power tool. Prevent the contacts from shortcircuiting (e. g. by protecting them with adhesive tape). Turn tool lock (2) in direction indicated by arrow (a) and remove tool (b). 12. Technical Specifications 8. Maintenance Explanatory notes on the information on page 3. Changes due to technological progress reserved. The vent slots of the machine should be cleaned periodically. U Ah m = Voltage of battery pack = capacity of the battery pack = weight (with smallest battery pack) 9. Accessories Use only genuine Metabo accessories. dsWn1ima.axm.ax.==== no-load speed maximum solid drill diameter maximum impact rate single impact force Use only accessories which fulfil the requirements Measured values determined in conformity with and specifications listed in these operating instruc- EN 60745. tions. Direct current See page 4. The technical specifications quoted are subject to A Chargers B Battery packs with different capacities. tolerances (in compliance with the relevant valid standards). Use battery packs only with voltage suitable for your power tool. Emission values These values make it possible to assess the C Metabo carrying strap emissions from the power tool and to compare D Tools with SDS-Plus shank different power tools. Depending on the operating 11