Metabo KFM 16-15 F Operating Instructions - Page 19

Fit accessories securely. If the machine is operated in a holder: secure the machine well. Loss of control can cause personal injury. A 10 HM universal inserts 6.23564 B Fastening screw for inserts 6.23566 C Cooling lubrication stick 6.23443 For a complete range of accessories, see www.metabo.com or the catalogue. 13. Repairs Repairs to power tools must only be carried out by qualified electricians! Contact your local Metabo representative if you have Metabo power tools requiring repairs. See www.metabo.com for addresses. You can download a list of spare parts from www.metabo.com. 14. Environmental Protection ENGLISH en organisational measures based on the adjusted estimates. Vibration total value (vector sum of three directions) determined in accordance with EN 60745: Kahh,,SSGG =Vibration emission value =Uncertainty (vibration) Typical A-weighted sound levels: LKLpWpAAA, = Sound pressure level = Acoustic power level KWA=Uncertainty The noise level can exceed 80 dB(A) during operation. Wear ear protectors! Electromagnetic disturbances: In individual cases, the speed may fluctuate temporarily if the machine is exposed to extreme external electromagnetic disturbances or the electronic restart protection may respond. In this case, switch the machine off and on again. Observe national regulations on environmentally compatible disposal and on the recycling of disused tools, packaging and accessories. Only for EU countries: never dispose of power tools in your household waste! Used power tools must be collected separately and handed in for environmentally compatible recycling in accordance with European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in national legal systems. 15. Technical Specifications Explanatory notes regarding the specifications on page 4. Subject to change in accordance with technical progress. n = No-load speed (maximum speed) PhbaPmm12 aaxx = Rated input power = Power output = Max. chamfer height = Max. chamfer width = Chamfer angle dmmin = Minimum pipe diameter = Weight without mains cable Measured values determined in conformity with EN 60745. Machine in protection class II ~ AC power The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards). Emission values These values make it possible to assess the emissions from the power tool and to compare different power tools. The actual load may be higher or lower depending on the operating conditions, the condition of the power tool or the accessories. Please allow for breaks and periods when the load is lower for assessment purposes. Arrange protective measures for the user, such as 19