Metabo KHE 5-40 Operating Instructions - Page 11

- Ensure good ventilation of the workplace and keep clean using a vacuum cleaner. Sweeping or blowing stirs up dust. - Vacuum or wash the protective clothing. Do not blow, beat or brush. 5. Overview See page 2. 1 Additional handle * 2 Wing screw (for adjusting the depth stop) * 3 Depth stop * 4 Clamping knob * 5 Bar handle (additional handle) * 6 Dust protection cap 7 Tool lock 8 Knob 9 Metabo VibraTech (MVT): integrated damping system 10 Locking lever (to release the continuous operation) * 11 Trigger 12 Handle 13 Adjustment wheel 14 Overloading and service display 15 Mode display * equipment-specific 6. Commissioning Before plugging in, check that the rated mains voltage and mains frequency, as stated on the type plate match your power supply. Always install an RCD with a maximum trip current of 30 mA upstream. Usescetioonnlyofe1x.t5enmsmio2n. cables with a minimum Extension cables must cross- correspond to the power consumption of the machine (cf Technical Specifications). If a cable roller is used, always roll up the cable completely. 6.1 Assembly of the bow handle or additional handle For safety reasons, always use the bow handle (5) or additional handle (1) supplied. MHE 5: Release the clamping ring by turning the clamping knob (4) anticlockwise. Adjust the bow handle (5) to the required position and angle. Tighten the clamping knob firmly. KHE 5-40: Open the clamping ring by turning the additional handle (1) anticlockwise. Secure the additional handle at the required angle. Tighten the additional handle. 7. Use ENGLISH en 7.1 Depth Stop Setting (only for KHE 5-40) Release the wing (2) screw. Set the depth stop (3) to the required drilling depth. Retighten the wing screw (2). 7.2 Positioning, removing tool Before inserting, clean tool shank and apply supplied special grease (accessories: Order no. 6.31800)! Use only SDS-max tools. The dust protection cap (6) prevents the ingress of drilling dust during operation. When inserting the tool, pay attention to ensure that the dust protection cap (6) is not damaged. Positioning tool: Hold the tool lock (7) in the front position when inserting the tool. Turn tool and insert until it engages. The tool is being locked. Pull on the tool to check that it is correctly seated. (It must be possible to move the tool a few centimetres in an axial direction.) Remove the tool: Pull the tool lock (7) backwards in direction indicated by arrow (a) and remove tool (b). See page 3. 7.3 Setting operating mode and chisel position Avoid levering with the machine when a chisel is fitted. KHE 5-40: Do not activate the switch button (8) until the motor has completely stopped. Only rotate the switch button (8) in the direction of the arrow. Turn the switch button (8) to select the desired operating mode. Hammer drilling Chiselling Setting the position of the chisel: The chisel can be locked in different positions. - Insert the chisel. - Turn the switch button (8) to the intermediate position (between setting and setting ). - Turn the chisel to the required position. - Turn the switch button (8) to position . - Turn the chisel until it engages. When a chisel is fitted, only operate the machine in the chiselling operating mode . MHE 5: Only operate the switch button (8) when the motor is at a standstill. Chiselling 11