Metabo SXE 450 TurboTec Operating Instructions - Page 9

10. Accessories Use only genuine Metabo accessories. For a complete range of accessories, see www.metabo.com or the main catalogue. 11. Repairs Repairs to electrical tools must be carried out by qualified electricians ONLY! If the mains connection cable of this machine is damaged, it must be replaced by the manufacturer or an authorized service centre to avoid hazard. Contact your local Metabo representative if you have Metabo power tools requiring repairs. For addresses see www.metabo.com. You can download a list of spare parts from www.metabo.com. 12. Environmental Protection Observe national regulations on environmentally compatible disposal and on the recycling of disused machines, packaging and accessories. Only for EU countries: Never dispose of power tools in your household waste! In accordance with European Guideline 2002/96/EC on used electronic and electric equipment and its implementation in national legal systems, used power tools must be collected separately and handed in for environmentally compatible recycling. ENGLISH en An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Vibration total value (vector sum of three directions) determined in accordance with EN 60745: ah, DS = Vibration emission value (sanding surfaces) Kahh,,DPS/Kh=,P Vibration emission value = Unsafe (vibration) (polishing) Typical A-effective perceived sound levels: LKLpWpAAA, = = KWA= Sound pressure level Acoustic power level Unsafe (noise level) During operation the noise level can exceed 80 dB(A). Wear ear protectors! Measured values determined in conformity with EN 60745. Machine in protection class II ~ Alternating current The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards). 13. Technical Specifications Explanatory notes on the specifications on page 3. Changes due to technological progress reserved. D = Diameter of support plate PnnnP00112,, TB TB = = = = = Nominal power input Power output Idle speed (setting wheel) Idle speed (TurboBoost switch) Speed at rated load (TurboBoost switch) s0 = Oscillating frequency at idle speed (setting wheel) s0, TB = Oscillating frequency at idle speed (TurboBoost switch) s1, TB = Oscillating frequency at rated load (TurboBoost switch) S = Oscillating circuit diameter m = Weight without mains cable The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. 9