Metabo WEPBA 17-150 Quick RT DS Operating Instructions - Page 11

- Do not direct the escaping particles and the exhaust air stream at yourself or nearby persons or on dust deposits - Use an extraction unit and/or air purifiers - Maintain good ventilation of the workplace and keep clean using a vacuum cleaner Sweeping or blowing will stir up dust - Vacuum or wash your protective clothing Do not blow, beat or brush Symbols on the tool: .......... Class II Construction V volts A amperes Hz hertz W watts max. diameter of the accessory .../min...... revolutions per minute rpm ......... revolutions per minute alternating current alternating current /direct current n rated speed The "C" and "US" indicators adjacent to the CSA Mark signify that the product has been evaluated to the applicable CSA and ANSI/ UL Standards, for use in Canada and the U.S., respectively. ENGLISH en 5.1 Attaching the additional handle Always work with the additional handle (12) attached! Attach the additional handle on the left or right of the machine and secure. 5.2 Attach the safety guard For safety reasons, always use the safety guard provided for the respective wheel! See also chapter 10. Accessories! Safety guard for grinding Designed for work with roughing wheels, flap sanding pads, diamond cut-off wheels. See illustration D on page 2. - Push and hold the lever (17). Place the safety guard (13) in the position indicated. - Release the lever and turn the safety guard until the lever engages. - Push the lever and turn the safety guard until the closed section is facing the operator. - Make sure that the guard is placed securely: The lever must engage and you should not be able to turn the safety guard. Use only accessories that are covered by at least 3.4 mm by the safety guard. 4. Overview See page 2. 1 "Quick"clamping nut * 2 Spindle 3 Auobalancer support flange * 4 Spindle locking button 5 Sliding on/off switch * 6 Handle 7 Electronic signal indicator * 8 Thumbwheel for selection of speed * 9 Trigger switch * 10 Transport eyelet, for WEPBA 17-125 Quick, WEPBA 17-150 Quick, WEPB 19-180 RT (Use only to transport the machine)* 11 Paddle switch * 12 Additional handle/Additional handle with vibration damping * 13 Safety cover 14 Support flange 15 2-hole nut * 16 2-hole spanner * 17 Lever for safety guard attachment * depending on equipment/not in scope of delivery 5. Commissioning Before using the tool, check to make sure that the rated mains voltage and mains frequency, as stated on the rating label, correspond to your power supply. Always install an RCD with a maximum trip current of 30 mA upstream. (Disassemble in reverse order.) 6. Attaching the grinding disc Prior to any conversion work: Pull the mains plug from the socket. The machine must be switched off and the spindle at a standstill. For reasons of safety, attach the cutting guard before performing cutting-off operations (see chapter 10. Accessories). 6.1 Locking the spindle - Press in the spindle locking button (4) and turn the spindle (2) by hand until the spindle locking button engages. 6.2 Placing the grinding wheel in position WA..., WBA..., WE...A...: See illustration A on page 2. The Autobalancer support flange (3) is permanently fitted on the spindle. As is the case with most other angle grinders, a detachable support flange is not necessary. The contact surfaces of the Autobalancer support flange (3), grinding wheel and the "Quick" clamping nut (1) must be clean. Clean if necessary. - Place the grinding wheel on the Autobalancer support flange (3). The grinding wheel must lie flat on the Autobalancer supporting flange. WPB...: See Figure B on Page 2. 11