Metabo WEPBA 17-150 Quick RT DS Operating Instructions - Page 14

en ENGLISH The fine mesh filter prevents coarse particles from entering the motor housing. Remove regularly and clean. F Hand protection Intended for work with backing pads, sanding plates, wire brushes and support plates, sanding pads, wire brushes and diamond Drill Bits for tiles. Install hand guard under the additional sidemounted handle. G Multiple position bar for side handle Permits numerous handle positions. H Bar side handle For a complete range of accessories, see www.metabo.com or the accessories catalogue. 11. Repairs Repairs to electrical tools must be carried out by qualified electricians ONLY! If the connection lead is damaged, it must be replaced by a special connection lead. Contact your local Metabo representative if you have Metabo power tools that need repairing. You can find the addresses on www.metabo.com. You can download a list of spare parts from www.metabo.com. Emission values These values make it possible to assess the emissions from the power tool and to compare different power tools. Depending on the operating conditions, the condition of the power tool or the accessories, the actual load may be higher or lower. For assessment purposes, please allow for breaks and periods when the load is lower. Based on the adjusted estimates, arrange protective measures for the user e.g. organisational measures. Vibration total value (vector sum of three directions) determined in accordance with EN 60745: ah, SG = Vibration emission value (surface grinding) ah, DS = Vibration emission value (sanding with sanding plate) ah, P = Vibration emission value (polishing) Kh,SG/DS/P = Uncertainty (vibration) Wear ear protectors! 12. Environmental protection The generated grinding dust may contain harmful substances. Dispose appropriately. Observe national regulations regarding environmentally compatible disposal and the recycling of old machines, packaging and accessories. 13. Technical specifications Explanatory notes on the specifications on page 4. Changes due to technological progress reserved. Ø = max. diameter of the accessory tmax,1 = max. permitted thickness of the clamping shank on accessory when using 2-hole nut (15) tmax,2=max. permitted thickness of clamping shank on accessory when using "Quick" clamping nut (1) tmax,3 = roughing disc/cutting disc: max. permitted thickness of accessory M = spindle thread l = length of the grinding spindle n* = no-load speed (maximum speed) Inm1V2*0 V = no-load speed (adjustable) = Current at 120 V = weight without mains cable * Machines with the designation WE... : Energy-rich, high-frequency interference can cause fluctuations in speed. The fluctuations disappear, however, as soon as the interference fades away. The technical specifications quoted are subject to tolerances (in compliance with the relevant valid 14 standards).