Metabo WP 13-125 Quick Operating Instructions - Page 22

en ENGLISH 12. Repairs Repairs to electrical tools must be carried out by qualified electricians ONLY! If the connection lead is damaged, it must be replaced by a special connection lead. Contact your local Metabo representative if you have Metabo power tools requiring repairs. For addresses see www.metabo.com. You can download a list of spare parts from www.metabo.com. 13. Environmental Protection The generated grinding dust may contain harmful substances. Dispose appropriately. Observe national regulations on environmentally compatible disposal and on the recycling of disused machines, packaging and accessories. Only for EU countries: Never dispose of power tools in your household waste! In accordance with European Directive 2012/ 19/EU relating to electrical and electronic waste and implementation of national law, used electrical tools must be collected separately and disposed of in an environmentally friendly manner at recycling centres. different power tools. Depending on the operating conditions, the condition of the power tool or the accessories, the actual load may be higher or lower. For assessment purposes, please allow for breaks and periods when the load is lower. Based on the adjusted estimates, arrange protective measures for the user e.g. organisational measures. Vibration total value (vector sum of three directions) determined in accordance with EN 60745: ah, SG = Vibration emission value (surface grinding) ah, DS = Vibration emission value (sanding with sanding plate) ah, P = Vibration emission value (polishing) KTyhp,SiGca/Dl SA/P-e=ffeUcnticveertpaeinrctyei(vveibdrastoiounn)d levels: LLKpWpAAA, KWA = = = Sound-pressure level Acoustic power level Uncertainty During operation the noise level can exceed 80 dB(A). Wear ear protectors! 14. Technical Specifications Explanatory notes on the specifications on page 4. Changes due to technological progress reserved. Ø = max. diameter of the accessory tmax,1 = max. permitted thickness of the clamping shank on accessory when using 2-hole nut (13) tmax,2 = max. permitted thickness of clamping shank on accessory when using "Quick" clamping nut (1) tmax,3 = roughing disc/cutting disc: max. permitted thickness of accessory M = spindle thread l = length of the grinding spindle n* = no-load speed (maximum speed) PnPmV12* = no-load speed (adjustable) = rated input power = power output = weight without mains cable Measured values determined in conformity with EN 60745. Machine in protection class II ~ AC Power * Machines with the designation WE... : Energy-rich, high-frequency interference can cause fluctuations in speed. The fluctuations disappear, however, as soon as the interference fades away. The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards). Emission values These values make it possible to assess the 22 emissions from the power tool and to compare