Microsoft MN700 User Guide - Page 9
Status light, Blinking - reset
UPC - 805529291836
View all Microsoft MN700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Antenna Power, Modem, and Wireless lights Ethernet port lights, which correspond to the Ethernet ports on the back of the base station Optional stand The front of the base station has seven status lights. The following table describes the behavior of each light. Status light On Off Blinking Power Green: Ready Orange: Resetting, restoring factory defaults, or upgrading firmware Not receiving power Error* Modem Modem connected and turned on Modem off or not connected Data being sent or received through the modem Wireless Radio enabled Radio disabled Data being sent or received wirelessly Ethernet port (4) Ethernet device connected and on Ethernet device off Data being sent or received or not connected over Ethernet connection *If the Power light is blinking, reset the base station by using the procedure described later in this chapter. Chapter 1: Introduction 3