Miele Boost CX1 Parquet Operating instructions/Installation instructions - Page 20
HEPA AirClean SF-HA 60 white
View all Miele Boost CX1 Parquet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
en-US Lift up the dust container handle and hold it in this position. Press the side flap firmly into position. Reinsert the dust container in the vacuum cleaner (Fig. 28). When to replace the exhaust filter Depending on the model, your vacuum cleaner will be equipped as standard with one of the following exhaust filters: - Hygiene AirClean SF-HY 60 (turquoise) Replace this exhaust filter after approx. one year. Make a note of the date on the exhaust filter. - HEPA AirClean SF-HA 60 (white) Replace this exhaust filter if the TimeStrip® filter change indicator is completely red. The display will be completely filled with red after approximately 50 operating hours; this corresponds to approximately one year of average use. You can continue vacuuming in this case. However, the suction power will be reduced as will the effectiveness of the filter. Replacing the exhaust filter (Figs. 42 + 43) Press the release catch on the exhaust filter compartment flap and remove the flap (Fig. 07). Pull the exhaust filter removal tab up and pull the exhaust filter forward to remove it (Fig. 42). Place the insertion aids that are located on both sides of the new exhaust filter into the guides on the exhaust filter compartment (Fig. 43). Push the exhaust filter back and up. Press the exhaust filter firmly into position until it clicks into place. If you have fitted your vacuum cleaner with a HEPA AirClean exhaust filter, press the TimeStrip® filter change indicator (Fig. 09). After approx. 10-15 seconds a thin red line will appear in the left-hand side of the display (Fig. 10). Fit the exhaust filter compartment flap carefully in the bottom of the exhaust filter compartment and close the flap, making sure it clicks into position (Fig. 11). Replacing the thread lifters (Fig. 44) (not possible on models with EcoTeQ Plus floorhead) The thread lifters on the suction inlet to the floorhead can be replaced. Replace the thread lifters if the pile has worn down. Lift the thread lifters out of the slots. To do so use a suitable tool, e.g., a flat-head screwdriver. Install new thread lifters. Replacement parts are available from your Miele dealer or through Miele Service. 20