Miele CM 6350 Operating instructions - Page 81

Electrical connection All electrical work should be performed by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. Verify that the voltage, load and circuit rating information found on the data plate match the household electrical supply. This data must match to prevent damage to the coffee system. If in doubt, consult a licensed electrician. The data plate can be found behind the drip tray inside the coffee system. The appliance is supplied with a power cable ready for connection to an AC 120 V 60 Hz supply. Connect the coffee system only to a properly installed outlet with grounding contact. Fuse rating must be at least 15 A. The socket should be next to the appliance and easily accessible. To reduce the risk of injury, do not drape cord over the counter top or table top where it can be pulled on by children or tripped over unintentionally. Do not connect the appliance to a power inverter or directly to power produced outside of the normal electrical grid (i.e. direct solar or wind power source). Direct connection to such power sources can cause power surges and tripped breakers when the appliance is turned on, and could damage the appliance. Do not connect the appliance to energy saving plugs or outlets. The reduction of power to the appliance caused by these devices will cause the appliance to run hot and may damage it and/or shorten its usable life. Do not operate any appliance with a damaged cord or plug. Contact Miele Technical Service. If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or contact Miele's Technical Service Department. WARNING: THIS APPLIANCE MUST BE GROUNDED 81