Miele Dynamic U1 HomeCare - SHCE0 Operating instructions - Page 20

en-US  Lift up the filter frame until it clicks and remove the old filter. Hold the filter by the clean, unsoiled section to remove it.  Replace with a new dust compartment filter.  Close the filter frame.  Insert the FilterBag into the holder as far as it will go.  Close the dust compartment lid securely, making sure it clicks into position. Take care not to pinch the FilterBag when doing so. When to replace the exhaust filter Depending on the model, your vacuum cleaner will come standard with one of the following exhaust filters (Fig. 02): a AirClean Replace this filter every time you start a new packet of Miele FilterBags. An AirClean exhaust filter is supplied with every packet of Miele FilterBags. b Active AirClean 30 (black) c HEPA AirClean 30 (white) Replace this filter when the exhaust filter change indicator is completely red (Fig. 07). This occurs after approx. 50 hours of operation, which is equivalent to about a year of average use. The vacuum cleaner can still be used. However, the power will be reduced as will the effectiveness of the filter if it is not replaced in due time. Replacing the AirClean exhaust filter (Fig. 28, 29, + 30) Do not use more than one exhaust filter at a time.  Open the exhaust filter compartment lid.  Remove the filter frame.  Open the filter frame and remove the used AirClean filter by one of the clean, unsoiled sections.  Replace it with a new AirClean exhaust filter. If you wish to install an Active AirClean 30 or HEPA AirClean 30 exhaust filter, see "Replacing one type of exhaust filter with another."  Secure the catch on the filter frame and reinsert the frame in the exhaust filter compartment.  Close the exhaust filter compartment lid. Replacing the Active AirClean 30 and HEPA AirClean 30 exhaust filters Do not use more than one exhaust filter at a time.  Open the exhaust filter compartment lid.  Remove the exhaust filter (Fig. 31).  Insert the new exhaust filter and press the exhaust filter change indicator (Fig. 05). After approx. 10 - 15 seconds, a thin red stripe will appear on the left-hand side of the display (Fig. 06). 20